Found a concrete grinder with diamond bit inserts at Sunbelt rentals. Picked it up on a Friday and returned it on Monday... total cost $134.00. (Why didn't we do this the first time?)
Steve worked all weekend to grind off the concrete stain we applied and the 1/16th inch of concrete to expose the aggregate. This was a long and frustrating process.
Yes it was frustrating.... and not because the concrete was so tricky to grind down. It was frustrating because I couldn't figure out how to make the three grinding blocks stay put on the machines rotating wheel. They're held in place with small hardwood wedges and I wasn't hammering them into place good enough. A block, wedge and/or two blocks would go flying across the room without warning. ACK! Sometimes after 10 minutes of grinding, sometimes after 10 seconds of grinding. That and the ShopVac filter would clog up every 1/2 hour or so... but over all it wasn't awfully tricky, just my ineptness made it take longer than it should have. -Steve
The grinder did a great job, but left quite a bit around the edges and the finish wasn't as smooth as we had hoped for. So back to Sunbelt for more equipment! They located a hand grinder that would get right up to the edge of the wall, plus the diamond bit was a little finer so it could smooth out the swirls. (Approx. $50)
Sorry Steve... one more night of conrete dust in your hair, eyes, nose... but it was worth it. With a final coat of concrete sealer we finally have the floor we wanted.
I'm still finding concrete dust in places I didn't know were places!!! ACK!
-Steve
